Filament Dryer & Filament Container for 3D Printing
PrintDry Filament Dryer PRO3
Description
Outside Dimension: | 340mm (L) x 285mm (W) x 350mm (H) |
It’s the ultimate filament dryer you need for quality 3D printing!
Digital Display
- Easily adjust the temperature with 6 presets (35ºC, 45ºC, 55ºC, 65ºC, 75ºC, and 85ºC).
- Built-in timer with a maximum time of 48 hours.
Dryer Temperature Measurement
PrintDry dryer is regulating its temperature by using a close-loop design. When the temperature is above the preset value, the heating unit will be turned off. On the other hand, if the temperature is below the preset value, the heating unit will be turned on. Therefore, the heating unit always have its ON/OFF cycle. When checking the dryer temperature, the following equipment and method are used.
Device: PH-1016U Multi-channel Temperature Measurement Device with T, J, K Type Thermocouples, 0.1℃ temperature resolution and 0.5℃ temperature accuracy.
Temperatures are measured at 4 locations — 3 locations inside a dryer and 1 location outside the dryer.
- T1: measured at the hot air outlet (close to the dryer temperature sensor) as shown in the picture below.
- T2: measured in the center half way in the height.
- T3: measured in the center about 50mm below the lid internal surface.
- T4: room temperature.
The temperature distribution inside the dryer is NOT uniform. The temperature in a place close to the hot air vent is higher and the temperature in a place far away from the hot air vent is lower.
Double-wall Structure
Spool Adapter included
- 2 metal shafts
- 4 big spool adapters
- 4 small spool adapters
Additional information
Weight | 8 lbs |
---|
You must be logged in to post a review.
Reviews
There are no reviews yet.